I set up NUT on my server to monitor the status of 2 UPS’s connected via USB, an eaton and a cyberpower. Nut fires up fine when I tell systemd to run all the pieces, but when I reboot, they are active but dead. they dont wake up and work until I manually load them again.

Theres no error anywhere. it just wont load itself on boot. why?

    • muusemuuse@sh.itjust.worksOPEnglish
      3·
      23 hours ago
      sean@hooty:~$ systemctl status nut-driver@printerUPS.service
○ nut-driver@printerUPS.service - Network UPS Tools - device driver for NUT device 'printerUPS'
     Loaded: loaded (/usr/lib/systemd/system/nut-driver@.service; enabled; preset: disabled)
    Drop-In: /usr/lib/systemd/system/service.d
             └─10-timeout-abort.conf
             /etc/systemd/system/nut-driver@printerUPS.service.d
             └─nut-driver-enumerator-generated-checksum.conf, nut-driver-enumerator-generated-devicename.conf, nut-driver-enumerator-genera>
             /etc/systemd/system/nut-driver@.service.d
             └─override.conf
     Active: inactive (dead)
       Docs: man:upsdrvsvcctl(8)
             https://www.networkupstools.org/historic/v2.8.4/docs/man/upsdrvsvcctl.html
             man:ups.conf(5)
             https://www.networkupstools.org/historic/v2.8.4/docs/man/ups.conf.html
             man:nut.conf(5)
             https://www.networkupstools.org/historic/v2.8.4/docs/man/nut.conf.html
             man:usbhid-ups(8)
             https://www.networkupstools.org/historic/v2.8.4/docs/man/usbhid-ups.html