Hi. I am not sure I understand the issue correctly but I will try to help. I have two NucBox G3 and I never had issues with them, however I did had to understand something about USB ports. What is the maximum power in watts the g3 can provide to each USB 3 is 5W (source: their support after I emailed them).
I was noticing that a nvme I had attached via usb to my g3/truenas was faiing constantly (https://sh.itjust.works/post/20409332) and in the end I realised this was due to power draw. I moved the “heavy consumption” nvme to the internal port and used the “low consumption” outside and I had no issue at all.
I would also like to say that I had similar issues also on the PI4Bs (due to power consumption) and they too were hell to debug.
I hope it helps and good luck.
Hi. I am not sure I understand the issue correctly but I will try to help. I have two NucBox G3 and I never had issues with them, however I did had to understand something about USB ports. What is the maximum power in watts the g3 can provide to each USB 3 is 5W (source: their support after I emailed them). I was noticing that a nvme I had attached via usb to my g3/truenas was faiing constantly (https://sh.itjust.works/post/20409332) and in the end I realised this was due to power draw. I moved the “heavy consumption” nvme to the internal port and used the “low consumption” outside and I had no issue at all. I would also like to say that I had similar issues also on the PI4Bs (due to power consumption) and they too were hell to debug. I hope it helps and good luck.